MobilSat MSP-C Manual de usuario

D3 Mobile Satellite Internet Controller Configuration and Operation Manual Preliminary May 2006-05-11

Other Modems currently displayed in the Satellite System drop down box are; UnaSAT, Aloha, and Generic. These currently function in Generic mode. I

HughesNet Required! The symbol rate is enter in Msps (Mega Symbols per Second). Again this value is only needed in HughesNet mode. Example; 30,0

Isolation then setting Isolation Optimization to low should offer a minimal acceptable isolation for TX use. Medium When set to Medium, CrossPol is

The Azimuth Search Window is the horizontal search area of the Mount after a Reference Satellite has been located. The D3 will determine the calculat

Manual Location (Disabled) Disabled When Manual Location is disabled the D3 reads the Location values (Latitude and Longitude) from the GPS module

adjustment is not necessary on most F2 and F3 mounts some dealers like the ability to set this stow zero position. The XF mounts actually have both E

degrees. Seventeen degrees on the F1 and F3 mounts allows the Dish to rotate 360+ degrees in azimuth without the LNB Arm Assembly hitting objects on

If the D3 Satellite ID Table is current (valid) and the Target Satellite (Satellite Longitude) is valid in this table then Manual Sat ID should be Dis

Table. The more errors in this table the more likely the search time for the Target Satellite will increase. It is also possible that a Reference Sa

Features Front Panel Search, Stow, and Power Commands LED (Status Indicators) TCPIP/LAN Interface HTML Configuration and Operation Pages Telnet C

First Steps; • Press Power, Search, and Stow Buttons at the same time on the front of D3 Controller until all LEDs on Front Panel Illuminate. This i

Screenshot 3 • Turn off power to the D3 Controller, and then re-apply power. The Green LED Power indicator to the Left of the Power Button will

Screenshot 4 • In the Blue Field on the left side of this page under Standard Functions click on Configuration. This will send you to the D3 Con

It is important that these are configured properly or the system will not work. • For more information on how to set the (Network Configurations),

• The Satellite System has several options currently available. Use the light blue down arrow to select the correct system type. • Once these 5 se

Screenshot 7 D3 Configuration Definitions This document describes the function and typical use of each configuration item. See Screenshots 5,

Default to 255.255.255.0, see your IT manager if changes to this value are necessary. Modem Gateway (192.168.0.1) This value is set to the modem ad