If the D3 Satellite ID Table is current (valid) and the Target Satellite
(Satellite Longitude) is valid in this table then Manual Sat ID should be
Disabled.
Enabled
If there is not a Valid Target Satellite in the current D3 Sat ID Table this
feature can be enabled. When Enabled the user must input valid data in
the Sat ID RF, Sat ID Symbol Rate, and the Sat ID Viterbi.
Another condition where Manual Sat ID would be Enabled could happen
if a Reference Satellite recently had changes where it would ID the same
as the Target Satellite. Under this condition the user would need to
change the Target Satellite Manual Sat ID values.
Use Sat ID Table (Enabled)
The D3 has an internal Satellite ID Table which covers most of the Ku
Band Satellites around the world. This table is updated by firmware
periodically. The D3 uses this table to ID any reference satellite in the sky
that is within approximately +/_ 45 degrees of the “Satellite Longitude”,
Target Satellite or Target Longitude. Once a reference Satellite within this
range has been ID’ed the D3 will calculate the correct azimuth distance to
the Target Satellite.
Terms; Reference Satellite is any satellite that can be used to
determine the correct location of the Target Satellite.
Target Satellite
is the Satellite that the D3 has been
configured to search and Peak. This is selected by
inputting a valid Satellite Longitude in Configuration.
Target Satellite, Target Longitude, and Satellite Longitude
are synonymous in this document.
Enabled
If the D3 Satellite ID Table is current (valid) the “Use Sat ID
Table” should be Enabled. A current Satellite ID Table allows the
D3 to perform faster searches.
Disabled
If it has been a year or more since the last use of the D3 it is
possible that there will be several or many errors in the Satellite
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales